Are either or both of you developing by inspection in trays?
Bazz8 wrote:I use a BTZS file which after testing gives me a development time around 4-6 minutes,because of contrast I have been hesatent to rock the trays too much initially 15sec per minute.
This neg is constantly rocking the tray side to side and them lengthways.
I do not get to much scratching although I cut my fingered nails before developing negs.
This afternoon I developed 4 more all at 5 minutes.
First prints since September last year just too busy these days.
To answer your question Mick I do keep a eye on density by eye. I used LC29 14mm per 1000ml per sheet.
Users browsing this forum: No registered users and 76 guests